Author Topic: does RFduino be used for ws2813 led  (Read 1272 times)

daisy1988

  • RFduino Newbie
  • *
  • Posts: 2
  • Karma: +0/-0
    • View Profile
does RFduino be used for ws2813 led
« on: June 03, 2016, 01:19:35 AM »
ws2813 led is ws2812 updated version,it's dual-signal wires,signal break-point continuous transmission,i used it for first time,can ws2813 led be programmed by rfduion.
ws2813 led datasheet:http://www.normandled.com/upload/201605/WS2813%20LED%20Datasheet.pdf

danlsk

  • RFduino Jr. Member
  • **
  • Posts: 30
  • Karma: +0/-0
    • View Profile
Re: does RFduino be used for ws2813 led
« Reply #1 on: October 18, 2016, 12:21:19 PM »
RFduino has been able to run WS2812B. The WS2813 uses the same protocol and timing. It should work the same. It has a redundancy Din, hence, 2 Din-s for failure recovery: Din & Bin. You need to connect them correctly. I don't have this LED strip to verify yet. You can test with latest FastLED library.
« Last Edit: October 18, 2016, 12:33:17 PM by danlsk »

 

anything