I've completed a device prototype and used RFDuino DIP version.
We are evaluating it for the production and one requirement is
to update the sketch via BLE.
Is it possible to add this feature?
It will be up to sketch implementer to call and get the current sketch replaced, and
then reset from the lib function would start the updated sketch.
If there is some version of as the RFDloader protocol (apparently similar to avrdude) over
BLE, the other side can implement and use this protocol to upload the sketch
I have been using RFDuino for less than a month so my questions
may not be applicable or relevant.
I liked the RFDuino's rapid development capability and and the richness of Arduino sw/hw platform.
It may be possible to implement this using low level Nordic development and RFDuino but probably
to much effort.
If we can't overcome this obstacle, we'll look at other SOC solutions, like those from CSR
I've checked the following threads and apparently people
expressed the need for this.http://forum.rfduino.com/index.php?topic=425.0http://forum.rfduino.com/index.php?topic=272.0