Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hughanderson

Pages: [1]
1
Suggestions / Library call to reduce data rate for GZLL...
« on: March 06, 2016, 07:46:33 AM »

Hi,

I wonder if it would be possible to provide an RFduino GZLL call which reduced the data_rate, so that the RFduino GZLL can be used over longer distances?
Is it possible to do this? Perhaps by modifying and recompiling the libRFduinoGZLL.a?

Cheers Hugh

2
Suggestions / Problem with re-programming RFduino on Custom board
« on: January 12, 2015, 01:38:40 AM »
Hi,

I have developed a custom board for the RFduino, which provides some I2C based I/O, and uses a CP2103 for the USB/UART. The board seemed to be working fine, allowing me to upload small test applications to the RFduino. However, once I loaded the  MPU6050 orientation demo to the board (which incidentally works beautifully), I can no longer program the board. The impression I have is that perhaps some aspect of the high data rate (lots of 115200 baud data), or the short pause after a reset, or some other effect is preventing further programming.

When I attempt to program it, I can see the reset line going low then high, and  almost immediately I get the dreaded message
   get
   fail........ fail....... fail .......

I wondered if there was some timing diagram that could tell me the timing constraints on the DTR/RESET/Reprogram cycle? (I was wondering if my reset circuitry (which uses a 0.1uF cap, and a 10k pullup) might hold the pin low for too long - I notice that the RFDuino USB board uses a 0.01 uF cap (10000pf) and no pullup. I wondered if the longer low time of my circuit may be causing the issue.

Can someone suggest a possible debugging route for me?

Cheers Hugh

Pages: [1]